LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Removal & Installation >> Rear Brake Pads >> Removal

Rear Brake Pads: Removal

  1. Remove 2/3 of brake fluid from master cylinder reservoir. Raise and support vehicle. Mark wheel in relation to wheel studs. Remove wheel. Install 2 wheel lug nuts finger-tight to retain rotor. Position "C" clamp with one end on brake hose fitting bolt and other end on outer pad.
  2. Tighten "C" clamp until piston is bottomed in caliper. Remove and discard upper guide pin bolt securing caliper onto caliper mounting bracket. Rotate caliper downward on lower guide pin. Remove pads and pad shim. Discard pad shim.
scientia non olet · About LEMON Manuals