LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Body & Frame >> Seats >> Power Seat System >> Removal & Installation >> Power Seat >> Installation

Power Seat: Installation

  1. Install seat to vehicle. Connect seat belt wiring harness electrical connector, and lumbar air supply hose. Install seat adjuster nuts to studs. Tighten nuts to 50 N.m (37 lb ft). Install screw to rear outer nut cover. Tighten screw to 2 N.m (18 lb in). Install rear inner nut cover, and install screw to cover. Tighten screw to 2 N.m (18 lb in).
  2. Install inner and outer front nut covers, and install screws to covers. Tighten screws to N.m (18 lb in). Position front seat to original setting. Remove protective tape from trim and paint.
scientia non olet · About LEMON Manuals