Removal & Installation
- Disconnect negative battery cable. Raise and support vehicle. Disconnect Vehicle Speed Sensor (VSS) harness connector. Remove VSS mounting bolt. Remove VSS from transmission extension housing. On automatic transmission Remove VSS "O" ring. On Manual transmission remove speedometer driven gear, if necessary.
- To install, (on manual transmission install speedometer driven gear, if necessary) install the vehicle speed sensor with a new O-ring seal. Install the speed sensor bolt. On automatic transmissions, tighten bolt to 97 INCH lbs. (11 N.m). On manual transmissions, tighten bolt to 89 INCH lbs. (10 N.m). Connect the vehicle speed sensor electrical connector. Lower the vehicle. Check transmission fluid, add as required.