Cruise Control Switches

Cruise control switches are located at end of multifunction lever, which also serves as a turn signal lever. Cruise control switches include a SET (Set/Coast) button, a sliding main switch with OFF, ON and R/A (Resume/Accelerate) positions. Switch functions are described as follows:

1. OFF
   
   System disengages when switch is turned off.
2. ON
   
   System engages when switch is turned on.
3. R/A (Resume/Accelerate)
   
   Spring-loaded R/A switch will not initially set cruise speed, but when cruise has been disengaged by braking, momentarily sliding this switch to R/A position will cause cruise to resume previously set speed. This is resume function. Accelerate function occurs when R/A switch is held in position for one second or more. This causes vehicle to accelerate in one MPH increments until switch is released. When released, system maintains new set speed. By quickly pressing and releasing (tapping) this button, set speed is "tapped-up" in one MPH increments.
4. SET (Set/Coast)
   
   Spring-loaded SET button engages cruise. During engagement, if SET button is pressed and held, vehicle decelerates (cruise disengages) until button is released. When button is released, cruise engages and maintains new set speed. By quickly pressing and releasing (tapping) SET button, set speed is "tapped" down in one MPH increments.