LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Driveshaft & Universal Joints >> Drive Shaft & Universal Joints >> Adjustments >> Transmission Shimming

Transmission Shimming

Adding one shim at transmission mount decreases front universal joint angle 1/2 degree and increases rear angle 1/4 degree. Removing one shim from transmission mount increases front universal joint angle 1/2 degree and decreases rear angle 1/4 degree.

NOTE: Production transmission mount bolt is M10-1.5 x 35 mm. When using 2 or more shims, a M10-1.5 x 50 mm bolt must be used.
scientia non olet · About LEMON Manuals