LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Driveshaft & Universal Joints >> Drive Shaft & Universal Joints >> Adjustments >> Drive Shaft RUNOUT >> Two-Piece Drive Shafts

Two-Piece Drive Shafts

Measure rear drive shaft runout. Reference mark position of rear drive shaft yoke to pinion flange. Remove rear drive shaft and measure front drive shaft runout, both on tube and at tapered hole on splined end. If runout exceeds specifications, rotate rear drive shaft 180 degrees at pinion flange and install. Check runout again.

DRIVE SHAFT RUNOUT SPECIFICATIONS

Application Front Check Center Check Rear Check
One Piece Shaft .024" .055" .024"
Two Piece Shaft (1) .030" .040" .040"
(1) Measured with rear shaft connected to front shaft. Runout of front drive shaft must be within specification.
scientia non olet · About LEMON Manuals