LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> C3500 HD 8.1 G, Automatic >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Electronic Suspension - Suspension Damping & Automatic Level Control >> Repair Instructions >> Electronic Suspension Front Position Sensor Replacement (25 Series 4WD) >> Installation Procedure

Installation Procedure

    Fig 1: Front Position Sensor Replacement (25 series 4WD)
    GM516262Courtesy of GENERAL MOTORS COMPANY
  1. Install the position sensor on the vehicle.
  2. Refer to FASTENER NOTICE in Cautions and Notices.

    Install the bolt to the frame.

    Tighten 

    Tighten the bolts to 12 N.m (106 lb in).

  3. Install the (RTD) sensor link bracket bolt to the upper control arm.

    Tighten 

    Tighten the bolt to 9 N.m (80 lb in).

  4. Install the wheel speed sensor wire to the real time damping (RTD) sensor bracket.
  5. Connect the sensor harness connector to the vehicle harness connector.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals