LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> C3500 HD 6.5 F, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Instrument Panel Upper Trim Pad Replacement >> Removal Procedure

Removal Procedure

  1. Set the air flow control to the instrument panel (IP) vent position if equipped with air conditioning (A/C).
  2. Apply the parking brake to prevent the vehicle from moving.
  3. Move the shift lever all the way down (if the transmission is automatic).
  4. Tilt the steering wheel to the full down position.
  5. Remove the IP cluster trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
    6. Fig 1: View Of End Panel
    GM348724Courtesy of GENERAL MOTORS COMPANY
  6. Remove the end panels. Left is shown, right is similar.
  7. Remove the right side air outlets.
    8. Fig 2: View Of Assist Handle
    GM348728Courtesy of GENERAL MOTORS COMPANY
  8. Remove the assist handle by depressing the release tabs accessed through the air outlet duct holes.
  9. Remove the windshield pillar garnish moldings. Refer to Windshield Pillar Garnish Molding Replacement in Interior Trim.
  10. Remove the bolts retaining the pad to IP assembly.
    11. Fig 3: Identifying Ambient Light Sensor Electrical Connector
    GM350507Courtesy of GENERAL MOTORS COMPANY
  11. Left the trim pad up to disconnect the electrical connector (1) to the ambient light sensor on the underside of the trim pad.
    12. Fig 4: Identifying I/P Assembly Upper Trim Panel
    GM348717Courtesy of GENERAL MOTORS COMPANY
  12. Remove the trim pad from the assembly.
scientia non olet · About LEMON Manuals