LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> C3500 HD 6.5 F, Automatic >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Wheel And Steering Column - Tilt >> Repair Instructions >> Steering Shaft, Lower Bearing, and Jacket - Assemble - Off Vehicle (Floor Shift Lean Shaft)

Steering Shaft, Lower Bearing, and Jacket - Assemble - Off Vehicle (Floor Shift Lean Shaft)

    Fig 1: View Of Steering Column Support Assembly & TORX(R) Head Screws
    GM306322Courtesy of GENERAL MOTORS COMPANY
    IMPORTANT:

    Replace the steering column support assembly if the steering column support assembly has been staked 3 times.

  1. Refer to FASTENER NOTICE in Cautions and Notices.

    Attach the steering column support assembly (1) to the steering column jacket assembly with 4 new TORX® head screws (2).

    Tighten 

    Tighten the screws to 17 N.m (13 lb ft).

    2. Fig 2: View Of Steering Column Shaft Assembly & Steering Column Tilt Head Assembly
    GM664272Courtesy of GENERAL MOTORS COMPANY
  2. Install the steering column shaft assembly (2) into the steering column tilt head assembly (1).
    3. Fig 3: View Of Steering Column Tilt Head Assembly & Steering Column Support Assembly
    GM322998Courtesy of GENERAL MOTORS COMPANY
  3. Install the steering column shaft assembly with the steering column tilt head assembly (1) into the steering column support assembly (2).
  4. Move the tilt knob and push the steering column tilt head assembly up towards the steering column in order to lock the steering wheel lock shoes in place.
    5. Fig 4: View Of Pivot Pins At Steering Column Assembly
    GM299893Courtesy of GENERAL MOTORS COMPANY
    IMPORTANT:

    Replace the steering column support assembly if the steering column support assembly has been staked 3 times.

  5. Lubricate the pivot pins (1) with lithium grease.
  6. Firmly seat each pivot pin (1) into the steering column tilt head assembly.
  7. Stake the steering column support assembly in 3 locations around each pivot pin (1).
    8. Fig 5: View Of Adapter & Bearing Assembly
    GM343881Courtesy of GENERAL MOTORS COMPANY
  8. Install the adapter and bearing assembly (1) onto the steering column jacket assembly by performing the following steps:
    1. Align the tab on the adapter and bearing assembly (1) with the slot in the steering column jacket assembly.
    2. Push the adapter and bearing assembly (1) onto the steering column shaft assembly until the tab snaps into the slot.
    9. Fig 6: Turn Signal & Multifunction Switch Assembly & Screws
    GM415287Courtesy of GENERAL MOTORS COMPANY
    IMPORTANT:

    Be sure that the electrical contact of the turn signal and multifunction switch assembly (2) rests on the turn signal cancel cam assembly.

  9. Install the turn signal and multifunction switch assembly (2) onto the steering column tilt head assembly.
  10. Screw the 2 pan head tapping screws (1) into the turn signal and multifunction switch assembly (2).

    Tighten 

    Tighten the screws to 7 N.m (62 lb in).

  11. Install the tilt spring only. Refer to Tilt Spring - Assemble - Off Vehicle (Floor Shift) , Tilt Spring - Assemble - Off Vehicle (Column Shift) .
  12. Install the electronic lock module assembly. Refer to Electronic Column Lock Module - Assemble - Off Vehicle .
  13. Install the steering column into the vehicle. Refer to Steering Column Replacement .
  14. Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System in SIR.
scientia non olet · About LEMON Manuals