Steering Shaft, Lower Bearing, and Jacket - Assemble - Off Vehicle (Floor shift Export)
- Refer to FASTENER NOTICE
in Cautions and Notices.
Attach the steering column support assembly (2) to the steering column jacket assembly (3) with 4 new TORX® head screws (1).
Tighten
Tighten the 4 TORX® head screws to 17 N.m (13 lb ft).
- Install the steering shaft assembly (1) into the steering column support assembly (2) and the steering column jacket assembly (3).
- Install the adapter and bearing assembly (1) onto the steering column jacket assembly.
- Align the tab on the adapter and bearing assembly (1) with the slot in the steering column jacket assembly.
- Push the adapter and bearing assembly (1) onto the steering shaft assembly until the tab snaps into the slot.
- Install the turn signal and multifunction switch assembly (2) onto the steering column housing assembly.
- Screw the 2 pan head tapping screws (1) into the turn signal and multifunction switch assembly (2).
Tighten
Tighten the 2 pan head tapping screws to 7 N.m (62 lb in).
- Install the electronic lock module assembly. Refer to Electronic Column Lock Module - Assemble - Off Vehicle .
Fig 1: View Of TORX(R) Head Screws, Steering Column Support Assembly & Steering Column Jacket Assembly
Fig 2: View Of Steering Shaft Assembly, Steering Column Support Assembly & Steering Column Jacket Assembly
IMPORTANT:
The electrical contact of the turn signal and multifunction switch assembly (2) must rest on the turn signal cancel cam assembly.