LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> C3500 HD 6.5 F, Automatic >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Wheel And Steering Column - Standard >> Repair Instructions >> Steering Shaft, Lower Bearing, and Jacket - Assemble - Off Vehicle (Column shift Export)

Steering Shaft, Lower Bearing, and Jacket - Assemble - Off Vehicle (Column shift Export)

    Fig 1: View Of TORX(R) Head Screws, Steering Column Support Assembly & Steering Column Jacket Assembly
    GM389651Courtesy of GENERAL MOTORS COMPANY
  1. Refer to FASTENER NOTICE in Cautions and Notices.

    Attach the steering column support assembly (2) to the steering column jacket assembly (3) with 4 TORX® head screws (1).

    Tighten 

    Tighten the 4 TORX® screws to 17 N.m (13 lb ft).

    2. Fig 2: View Of Steering Shaft Assembly, Steering Column Support Assembly & Steering Column Jacket Assembly
    GM389648Courtesy of GENERAL MOTORS COMPANY
  2. Install the steering shaft assembly (1) into the steering column support assembly (2).
    3. Fig 3: View Of Adapter & Bearing Assembly
    GM343881Courtesy of GENERAL MOTORS COMPANY
  3. Install the adapter and bearing assembly (1) onto the steering column jacket assembly.
    4. Fig 4: View Of Linear Shift Assembly And Retaining Screws
    GM662202Courtesy of GENERAL MOTORS COMPANY
  4. Install the linear shift assembly onto the steering column support assembly.
  5. Secure the linear shift assembly to the steering column support assembly with 3 flat head tapping screws.

    Move the linear shift assembly out of the PARK position to install the lower socket tapping screw.

    Tighten 

    Tighten the 3 flat head tapping screws to 10 N.m (89 lb in).

    6. Fig 5: Turn Signal & Mulifunction Switch Assembly & Screws
    GM324887Courtesy of GENERAL MOTORS COMPANY
    IMPORTANT:

    Be sure that the electrical contact of the turn signal and multifunction switch assembly (2) rests on the turn signal cancel cam assembly.

  6. Install the turn signal and multifunction switch assembly onto the steering column housing assembly.
  7. Screw the 2 pan head tapping screws into the turn signal and multifunction switch assembly.

    Tighten 

    Tighten the 2 pan head tapping screws to 7 N.m (62 lb in).

  8. Install the electronic lock module assembly. Refer to Electronic Column Lock Module - Assemble - Off Vehicle .
scientia non olet · About LEMON Manuals