Removal Procedure
- The steering column
- The intermediate shaft(s)
- The steering gear
- Install the J 42640 in the steering column lower access hole.
- Mark the relationships of the following components:
- Mark the relationship of the bolt and clamp at both ends of the upper intermediate shaft.
- Mark the relationship of the upper intermediate shaft to the lower intermediate shaft.
- Remove the nut and bolt from the lower shaft to upper shaft connection.
- Remove the nut and bolt (1) from the upper shaft to steering column connection.
- Slide the intermediate shaft down, out of the steering column connection.
- Remove the accelerator pedal position sensor. Refer to Accelerator Pedal Position Sensor Replacement , or Accelerator Pedal Position Sensor Replacement , or Accelerator Pedal Position Sensor Replacement in Engine Controls.
- Slide the upper intermediate shaft towards the instrument panel, out of the lower intermediate shaft, and remove the shaft from the vehicle.
With wheels of the vehicle facing straight ahead, secure the steering wheel utilizing steering column anti-rotation pin, steering column lock, or a strap to prevent rotation. Locking of the steering column will prevent damage and a possible malfunction of the SIR system. The steering wheel must be secured in position before disconnecting the following components:
After disconnecting these components, do not rotate the steering wheel or move the front tires and wheels. Failure to follow this procedure may cause the SIR coil assembly to become un-centered and cause possible damage to the SIR coil. If you think the SIR coil has became un-centered, refer to your specific SIR coil's centering procedure to re-center SIR Coil.
Mark the relationship of the intermediate shaft components in order to assure proper installation.