LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> C3500 HD 6.5 F, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel And Steering Column - Tilt >> Repair Instructions >> Shift Lever Replacement - On Vehicle (With Tow/Haul Switch) >> Installation Procedure

Installation Procedure

    Fig 1: Locating Seal On The Shift Lever And TORX(R) Head Shift Lever Screw (With Tow/Haul Switch)
    GM362445Courtesy of GENERAL MOTORS COMPANY
  1. Install the shift lever (1).
  2. Connect the shifter electrical connector.
  3. Install the wire straps to the harness.
    4. Fig 2: Wiring Harness-To-Insturment Panel Retaining Pin
    GM748881Courtesy of GENERAL MOTORS COMPANY
  4. Install the harness retaining pin (4) to the instrument panel.
  5. Refer to Fastener Notice .
    Fig 3: View Of Knee Bolster Deflector Bracket & Nuts
    GM748879Courtesy of GENERAL MOTORS COMPANY

    Install the knee bolster deflector bracket and nuts (1).

    Tighten 

    Tighten the nuts to 9 N.m (80 lb in).

  6. Install the knee bolster. Refer to Knee Bolster Replacement (Luxury) , Knee Bolster Replacement (Non-Luxury) in Instrument Panel, Gauges and Console.
  7. Install the TORX® head screw.

    Tighten 

    Tighten the screw to 1.5 N.m (13 lb in).

  8. Roll the seal over the TORX® head screw.
  9. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .
scientia non olet · About LEMON Manuals