Inflatable Restraint Steering Wheel Module Coil Assemble - Off Vehicle (Floor Shift)
- Align the block tooth on the steering column shaft assembly (1) to the 12 o'clock position.
- Place the ignition switch in the LOCK position and remove the key.
- Install the wave washer (1) onto the steering column shaft assembly (2).
- If you are installing the existing inflatable restraint steering wheel module coil, you must center the inflatable restraint steering wheel module coil first. Refer to Inflatable Restraint Coil Centering - Off Vehicle (Column Shift And Floor Shift) .
- Align the inflatable restraint steering wheel module coil (4) with the horn tower on the turn signal cancel cam assembly (1).
- Slide the new inflatable restraint steering wheel module coil (4) onto the steering column shaft assembly (2).
- Firmly seat the retaining ring (3) into the groove on the steering column shaft assembly (2).
- Remove the centering tab from the new inflatable restraint steering wheel module coil (4).
- Discard the centering tab.
- Reconnect the inflatable restraint steering wheel module coil connector to the turn signal switch assembly connector.
- Attach the wire harness assembly (1) to the wire restraint clip (2).
- Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle (Floor Shift) .
- Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System .
IMPORTANT:
A new inflatable restraint steering wheel module coil will be pre-centered. Do not remove the centering tab from the new inflatable restraint steering wheel module coil until the installation is complete.
IMPORTANT:
The abrasion sleeve must be installed back onto the steering column wire harness assembly. The electronic lock module assembly wires and connector must be hanging out of the middle of the abrasion sleeve.