LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Astro Van Cargo, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 266 (Body Control Modules) >> Removal & Installation >> Driver Information Center (DIC) >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower tilt steering column to lowest position. Using small flat-bladed tool, pry out ignition switch cylinder bezel. Remove driver and passenger side outer trim cover. Remove instrument panel center trim panel. Remove driver side knee bolster. Remove passenger side instrument panel accessory panel. Remove instrument panel air outlet deflectors. See TRIM PANELS under REMOVAL & INSTALLATION in INSTRUMENT PANELS - AURORA article.
  2. Remove fasteners retaining trim plate to IP cluster. Disconnect electrical connectors and remove IP cluster trim plate from vehicle.
  3. Pull DIC rearward and disengage retaining clips to remove.
  4. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals