Automatic Transmission Range Selector Cable Lever Replacement

Removal Procedure





1. Remove the throttle body air inlet duct. Refer to Air Cleaner Assembly Replacement in Powertrain Management.
2. Remove the automatic transaxle range selector lever cable from the cable lever.
3. Remove the automatic transaxle range selector lever nut.
4. Remove the automatic transaxle range selector lever.

Installation Procedure





1. Install the automatic transaxle range selector lever.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the automatic transaxle range selector lever nut.
^ Tighten the automatic transaxle range selector lever nut to 32 Nm (23 ft. lbs.).
3. Install the automatic transaxle range selector lever cable to the automatic transaxle range selector lever.
4. Install the throttle body air inlet duct. Refer to Air Cleaner Assembly Replacement in Powertrain Management.