Automatic Transmission Range Selector Cable Bracket Replacement

Removal Procedure





1. Remove the throttle body air inlet duct. Refer to Air Cleaner Assembly Replacement in Powertrain Management.
2. Use a flat-bladed tool in order to remove the automatic transaxle range selector cable from the cable lever and the bracket. Refer to Automatic Transmission Range Selector Cable Replacement.
3. Remove the automatic transaxle range selector cable bracket bolts.
4. Remove the automatic transaxle range selector cable bracket.

Installation Procedure





1. Install the automatic transaxle range selector cable bracket.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the automatic transaxle range selector cable bracket bolts.
^ Tighten the automatic transaxle range selector cable bracket bolts to 25 Nm (18 ft. lbs.).
3. Install the automatic transaxle range selector cable to the cable lever and the bracket. Refer to Automatic Transmission Range Selector Cable Replacement.
4. Adjust the automatic transaxle range selector cable. Refer to Automatic Transmission Range Selector Cable Adjustment.
5. Install the throttle body air inlet duct. Refer to Air Cleaner Assembly Replacement in Powertrain Management.