Steering Column Trim Covers - Assemble

Assembly Procedure

- Tools Required
- J 41352 Modular Column Holding Fixture





1. Install the shroud protector (1) to the lower shroud (2).





2. Install the upper shroud (2) onto the column.
3. Slide the shift lever seal down the shift lever and install into the upper shrouds (2).

Notice: Refer to Fastener Notice in Service Precautions.

4. Secure the upper shroud (2) using 1 TORX (R) head screw (1).
- Tighten the screw to 1.5 Nm (13 inch lbs.).





5. Install the lower shroud (2) and secure by using 2 pan head tapping screws (1). Adjust the shift lever seal into the shroud.
- Tighten the screws to 3.5 Nm (31 inch lbs.).





6. Take the column out from the J 41352.
7. Remove the top piece of J 41352 from the steering column.
8. Remove J 41352 from the vise.