Multifunction, Turn Signal & Hazard Switch

Removal Procedure
1. Remove the HEADLAMP circuit breaker.

Caution: Refer to SIR Handling Caution in Service Precautions.

2. Disable the SIR system. Refer to Disabling the SIR System in Air Bags and Seat Belts.
3. Remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement in Air Bags and Seat Belts.
4. Remove the steering wheel. Refer to Steering Wheel Replacement.
5. Remove the steering column shrouds. Refer to Steering Column Trim Covers - Disassemble -Off Vehicle.
6. Disconnect the steering column electrical connectors.
7. Remove the turn signal multifunction switch connectors from the steering column electrical connector.
8. Remove the turn signal multifunction switch. Refer to Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle.

Installation Procedure
1. Install the turn signal multifunction switch. Refer to Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle.
2. Install the turn signal multifunction switch connectors to the steering column electrical connector.
3. Connect the steering column electrical connectors.
4. Install the steering column shrouds. Refer to Steering Column Trim Covers - Assemble -Off Vehicle.
5. Install the steering wheel. Refer to Steering Wheel Replacement.
6. Install the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement in Air Bags and Seat Belts.
7. Enable the SIR system. Refer to Enabling the SIR System in Air Bags and Seat Belts.
8. Install the HEADLAMP circuit breaker.