Tilt Head Housing - Assemble

Assembly Procedure

- Tools Required
- J23653-SIR Lock Plate Compressor





1. Align the race and upper shaft assembly (1) to the 12 o'clock position.
2. Put the lock cylinder in the LOCK position and remove the key.





3. Install the inner race (5).
4. Install the upper bearing inner race seat (4).
5. Install the upper bearing spring (3).
6. Lubricate the turn signal cancel cam assembly (2) using grease kit 26001884.
7. Install the turn signal cancel cam assembly (2).
8. Install the shaft lock shield assembly (1).





9. Install the bearing retaining using J 23653-SIR.
10. Remove J23653-SIR from the steering column.





11. Install the wave washer.
12. Install the SIR coil assembly. Refer to Inflatable Restraint
Steering Wheel Module Coil - Assemble - Off Vehicle.