Shoulder Belt Guide Adjuster Replacement

REMOVAL PROCEDURE

TOOLS REQUIRED
J29843-9 Door Lock Striker and Seat Belt Torx(R) Wrench

1. Unsnap the plastic cover from the shoulder belt guide.
2. Remove the front seat belt upper guide loop anchor nut.
3. Remove the center pillar upper trim panel.
4. Use the J 29843-9 in order to remove the bolts (3) from the shoulder belt guide adjuster bracket (1).
5. Remove the shoulder belt guide adjuster bracket (1) from the B-pillar (2).

INSTALLATION PROCEDURE

TOOLS REQUIRED
J29843-9 Door Lock Striker and Seat Belt Torx(R) Wrench

1. Install the shoulder belt guide adjuster bracket (1) to the B-pillar (2).

NOTE: Refer to Fastener Notice in Service Precautions.

2. Use the J 29843-9 in order to install the bolts (3) to the shoulder belt guide adjuster bracket (1).

Tighten
Tighten the front shoulder belt guide adjuster bracket bolts to 50 N.m (37 lb ft).

3. Install the center pillar upper trim panel.
4. Install the nut securing the upper guide loop anchor nut.

Tighten
Tighten the front seat belt upper guide loop anchor nut to 29 N.m (21 lb ft).

5. Snap the plastic cover to the shoulder belt guide.