Center Rear (Full Bench)

REMOVAL PROCEDURE
1. Remove the rear seat.
2. Remove the recliner trim cover.
3. Remove the rear seat riser.
4. Unhook the seat cushion cover retainers (2) from the seat frame.
5. Remove the bolts (3) securing the belts from the seat cushion frame.
6. Remove the center belts (1) from the seat.

INSTALLATION PROCEDURE
1. Install the center belts (1) to the seat.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the bolts (3) securing the center belts to the seat cushion frame.

Tighten
Tighten the rear seat center belt bolts to 53 N.m (39 lb ft).

3. Hook the seat cushion cover retainers (2) to the bottom of the seat frame.
4. Install the rear seat riser.
5. Install the recliner trim cover.
6. Install the rear seat.