LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2000 >> Venture V6-3.4L VIN E >> Repair and Diagnosis >> Restraints and Safety Systems >> Seat Belt Systems >> Seat Belt Retractor >> Service and Repair >> Rear (D Pillar)

Rear (D Pillar)

REMOVAL PROCEDURE

TOOLS REQUIRED
J 29843-9 Door Lock Striker and Seat Belt Torx� Wrench




1. Unsnap the cover (2) from the upper seat belt anchor.
2. Use the J29843-9 in order to remove the bolt (1) securing the upper seat belt anchor from the D-pillar (3).
3. Remove the upper seat belt anchor from the D-pillar (3).
4. Raise the carpeting in order to expose the lower seat belt anchor bolt (5).
5. Use the J 29843-9 in order to remove the bolt (5) securing the lower seat belt anchor (4) from the floor.
6. Unsnap the plastic trim cover from the D-pillar (3) trim panel. Slide the belt webbing through the slot.
7. Remove the driver's side rear quarter trim with RPO-C34, rear A/C only.




8. Use the J 29843-9 in order to remove the bolt securing the retractor from the D-pillar.
9. Remove the retractor side seat belt from the vehicle.
10. Remove the retractor from the vehicle.

INSTALLATION PROCEDURE

TOOLS REQUIRED
J 29843-9 Door Lock Striker and Seat Belt Torx� Wrench




1. Install the retractor side seat belt to the vehicle.
2. Install the retractor to the vehicle.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Use the J 29843-9 in order to install the bolt securing the retractor to the D-Pillar.

Tighten
Tighten the seat belt retractor bolt (D-pillar) to 43 N.m (32 lb ft).

4. Install the driver's side rear quarter trim with RPO-C34 rear AC only.




5. Slide the belt webbing through the slotted trim cover. Then snap the plastic trim cover to the D-Pillar (3) trim panel.
6. Install the lower seat belt anchor (4) to the floor.
7. Use the J 29843-9 in order to install the bolt (5) securing the lower seat belt anchor (4) to the floor.

Tighten
Tighten the lower seat belt anchor bolt (D-pillar) to 43 N.m (32 lb ft).

8. Install the upper seat belt anchor (1) to the D-Pillar (3).
9. Use the J29843-9 in order to install the bolt (1) securing the upper seat belt anchor to the D-Pillar (3).

Tighten
Tighten the upper seat belt anchor bolt (D-pillar) to 43 N.m (32 lb ft)

10. Snap the cover (2) to the upper seat belt anchor.