Rear (C Pillar)
REMOVAL PROCEDURETOOLS REQUIRED
J29843-9 Door Lock Striker and Seat Belt Torx(R) Wrench
1. Unsnap the cover from the upper seat belt (1) anchor.
2. Use the J29843-9 in order to remove the upper seat belt anchor bolt (2).
IMPORTANT: The lower seat belt anchor (4) attaches to the mini-buckle on the right side of the 60 percent seat cushion on vehicles equipped with a 60/40 split bench seat. Use a key or a small flat bladed tool in order to release the seat belt anchor from the mini-buckle.
3. Lift the trim cover in order to expose the lower seat belt anchor bolt (5).
4. Use the J29843-9 in order to remove the bolt (5) securing the lower seat belt anchor (4) from the C-pillar.
5. Unsnap the cup holder/armrest trim cover (3) from the passenger's side.
6. Remove the left body side front trim panel.
7. Use the J29843-9 in order to remove the bolt securing the seat belt retractor from the C-pillar.
8. Remove the seat side belt retractor from the C-pillar.
INSTALLATION PROCEDURE
TOOLS REQUIRED
J29843-9 Door Lock Striker and Seat Belt Torx(R) Wrench
1. Install the seat belt retractor to the C-pillar.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Use the J 29843-9 in order to install the bolt securing the seat belt retractor to the C-pillar.
Tighten
Tighten the seat belt retractor bolt (C-pillar) to 43 N.m (32 lb ft).
3. Install the left body side front trim panel.
4. Snap the cup holder/armrest trim cover (3) in place on the passenger's side.
5. Use the J 29843-9 in order to install the bolt (5) securing the lower seat retractor side belt anchor (4) to the C-pillar.
Tighten
Tighten the lower seat belt anchor bolt (C-pillar) to 43 N.m (32 lb ft).
6. Install the seat belt anchor to the mini-buckle on the vehicles with the 60/40 split bench.
7. Use the J 29843-9 in order to install the bolt (2) securing the upper seat belt anchor (1).
Tighten
Tighten the upper seat belt anchor bolt (C-pillar) to 43 N.m (32 lb ft).
8. Snap the cover onto the upper seat belt anchor (1).