Outboard-Third Row Seat

REMOVAL PROCEDURE

IMPORTANT: The child seat tether attaches or anchors in two different ways. The tether strap attaches to the third row outboard lower seat belt anchor bracket or the third row seat rise depending on the seat configurations. Use the child seat tether strap only in the second row.




1. Slide the rear seat belt sleeve to the upward position in order to expose the tether strap anchor.
2. Unclip the tether strap spring clip from the seat belt anchor plate.




3. Remove the tether strap from underneath the head restraint if equipped.
4. Remove the tether strap from the vehicle.

INSTALLATION PROCEDURE




1. Route the tether strap underneath the second row seat head restraint it equipped.




2. Remove the staple from the seat belt anchor sleeve. Then discard the staple.
3. Slide the sleeve to the upward position in order to expose the seat belt anchor.
4. Clip the tether strap spring clip to the anchor plate. Verity that the spring clip end closes once the tether strap spring clip is attached to the anchor plate.