Clockspring Assembly / Spiral Cable: Service and Repair

REMOVAL PROCEDURE
1. Perform the Air Bag(s) Arming and Disarming Procedure.
2. Remove the inflatable restraint steering wheel module.
3. Remove the upper and lower steering column shrouds.
4. Remove the steering wheel.
5. Disconnect the radio steering wheel controls inline connector C205 located at the base of the steering column.
6. Remove the wiring harness straps from the steering wheel column wiring harness.
7. Remove the retaining ring.
8. Remove the inflatable restraint steering wheel module coil from the steering shaft.

INSTALLATION PROCEDURE
1. Install the inflatable restraint steering wheel module coil to the steering shaft.
2. Install the retaining ring.
3. Route the lower coil wiring harness along steering column and install the necessary wiring harness straps.
4. Connect the radio steering wheel controls inline connector C205.
5. Install the steering wheel.
6. Install the upper and lower steering column shrouds.
7. Install the inflatable restraint steering wheel module.
8. Enable the SIR system.