LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2000 >> Venture V6-3.4L VIN E >> Repair and Diagnosis >> Relays and Modules >> Relays and Modules - Steering and Suspension >> Relays and Modules - Suspension >> Compressor/Pump Relay >> Service and Repair >> Automatic Level Control Relay Replacement (VIN U)

Automatic Level Control Relay Replacement (VIN U)

Removal Procedure





1. Remove the ELC/TRAILER fuse.
2. Remove the inflator air valve opening cover by pulling the lever inboard.
3. Remove the inflator control panel retainers.
4. Remove the bolts/screws from the inflation timer relay.





5. Remove the electrical connector from the inflation timer relay.

Installation Procedure





1. Install the electrical connector to the inflation timer relay.

Notice: Refer to Fastener Notice in Service Precautions.





2. Install the bolts/screws to the inflator relay.
- Tighten the inflator relay bolts/screws to 2 Nm (18 inch lbs.).
3. Install the inflator control panel retainers.
4. Install the inflator air valve opening cover by pushing the lever outboard.
5. Install the ELC/TRAILER fuse.
scientia non olet · About LEMON Manuals