Accelerator Controls Cable Bracket Replacement

REMOVAL PROCEDURE




1. Disconnect the accelerator cable cross slug from throttle body slot.
2. Depress the tangs and remove the accelerator cable from accelerator cable bracket.




3. If applicable disconnect the cruse control cable from the throttle lever and accelerator bracket.




4. Remove the nut (3) and bolts (1,2) holding the accelerator cable bracket to the throttle body.
5. Remove the accelerator cable bracket.

INSTALLATION PROCEDURE




1. Position the accelerator cable bracket on the throttle body.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the nut (3) and bolts (1,2).

Tighten
^ Tighten the bolts in sequence (2,1) to 13 N.m (115 lb in).
^ Tighten the nut in sequence (3) to 10 N.m (89 lb in).




3. Connect the cruise control cable into accelerator cable bracket.
4. Connect the accelerator cable cross slug to the throttle body slots.
5. If applicable connect the cruse control cable to the throttle lever and accelerator bracket.