Evaporative Emission Control Canister: Service and Repair

REMOVAL PROCEDURE
For proper routing and replacement of canister hoses, refer to Emission Hose Routing Diagram. When replacing the hoses, use 6148M or equivalent.
1. Refer to Lifting and Jacking the Vehicle in Service Precautions. Raise the vehicle.
2. Disconnect the [1][2]EVAP lines.
3. Be sure to mark the [1][2]EVAP lines to ensure correct Installation.
4. Remove the EVAP canister retainer Bolt.
5. Remove the EVAP canister (2).

INSTALLATION PROCEDURE
1. Install the EVAP canister (2).

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the EVAP canister retainer bolt.

Tighten
Tighten the EVAP canister retainer bolt to 10 N.m (88 lb in)

3. Connect the lines to the EVAP canister. Be sure to connect the lines to the EVAP canister correctly.
4. Lower the vehicle.