Heater Hose Replacement - Inlet

REMOVAL PROCEDURE




1. Remove the air cleaner cover and duct assembly.
2. Disconnect the wiper linkage. Refer to Wiper Motor Crank Arm Replacement in Wiper Washer Systems. Wiper Motor Crank Arm Replacement
3. Drain the cooling system. Refer to Draining and Filling Cooling System in Engine Cooling. Service and Repair
4. Disconnect the inlet hose (1) from the inlet pipe (2).




5. Disconnect the inlet hose from the heater core.
6. Remove the inlet hose.

INSTALLATION PROCEDURE




1. Install the inlet hose.
2. Connect the inlet hose to the heater core and position the hose clamp as indicated.




3. Connect the inlet (1) hose to the inlet pipe (2).
4. Refill the coolant.
5. Connect the wiper linkage. Refer to Wiper Motor Crank Arm Replacement in Wiper Washer Systems. Wiper Motor Crank Arm Replacement
6. Install the air cleaner cover and duct assembly.