Vacuum Reservoir HVAC: Service and Repair

VACUUM TANK REPLACEMENT

REMOVAL PROCEDURE




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in Vehicle Lifting.
2. Disconnect the vacuum hose from the vacuum tank (1).
3. Remove the two nuts (2) that secure the vacuum tank.
4. Remove the vacuum tank (3).

INSTALLATION PROCEDURE




1. Install the vacuum tank (3).

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the vacuum tank mounting nuts (2).

Tighten
Tighten the nuts to 10 N.m (89 lb in).

3. Connect the vacuum hose (1) to the vacuum tank.
4. Lower the vehicle.