Blower Motor Resistor Replacement - Auxiliary

REMOVAL PROCEDURE




1. Remove the left side rear quarter trim.
2. Disconnect the electrical connector (1) from the blower motor resistor.




3. Remove the blower motor resistor attaching screws.
4. Remove the blower motor resistor.

INSTALLATION PROCEDURE




1. Install the blower motor resistor.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the blower motor resistor attaching screws.

Tighten
Tighten the blower motor resistor attaching screws to 1.6 N.m (14 lb in).




3. Connect the electrical connector (1) to the blower motor resistor.
4. Install the left rear quarter trim panel.