Radiator Hose Replacement - Inlet

Removal Procedure

^ Tools Required
- J 38185 Hose Clamp Pliers





1. Partially drain the coolant. Refer to Draining and Filling Cooling System.
2. Disconnect the inlet hose from the thermostat housing using the J 38185.
3. Disconnect the inlet hose from the radiator using the J 38185.
4. Remove the inlet hose.

Installation Procedure





1. Install the inlet hose in position and align the marks on the hose.
2. Connect the inlet hose to the radiator using the J 38185.
3. Connect the inlet hose to the thermostat housing using the J 38185.

Important: To properly fill the system you must use of the air bleed vents. Refer to Draining and Filling Cooling System.

4. Refill the coolant. Refer to Draining and Filling Cooling System.