Throttle Body Heater Hose Replacement - Outlet

Removal Procedure

^ Tools Required
- J 38185 Hose Clamp Pliers





1. Remove the air cleaner and duct assembly. Refer to Air Filter Element Replacement in Computers and Controls.
2. Drain the coolant until the coolant level is below the throttle body heater hoses. Refer to Draining and Filling Cooling System.
3. Use the J 38185 in order to remove the hose clamp.
4. Remove the throttle body heater outlet hose.

Installation Procedure





1. Install the throttle body heater outlet hose.
2. Use the J 38185 in order to install the hose clamps.
3. Fill the cooling system. Refer to Draining and Filling Cooling System.
4. Install the air cleaner and duct assembly. Refer to Air Filter Element Replacement in Computers and Controls.