Rear Side Door Rear Edge In/Out Adjustment

Rear Side Door Rear Edge In/Out Adjustment

Removal Procedure

1. Open the sliding door.




2. Loosen 2 screws on the rear door striker.
3. Move the striker in and out in order to adjust the rear edge of the sliding door, as needed.



Installation Procedure






Notice: Refer to Fastener Notice in Cautions and Notices.

1. Hand tighten the 2 sliding door rear striker screws.

Tighten the sliding door rear striker screws to 25 N.m (18 lb ft).

2. Close the sliding door.