Automatic Transmission Dipstick - Dipstick Tube: Service and Repair

Removal Procedure





1. Remove the fluid level indicator.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Remove the fluid filler tube bracket bolt from the fluid filler tube bracket.
4. Remove the fluid filler tube.

Installation Procedure

Important: Do NOT place the fluid filler tube seal on the fluid filler tube when installing the tube or damage to the seal will result.





1. Install the fluid filler tube seal in the transaxle.
2. Position the fluid filler tube.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the fluid filler tube bracket bolt through the fluid filler tube bracket.
- Tighten the fluid filler tube bracket bolt to 13 Nm (115 inch lbs.).
4. Lower the vehicle.
5. Install the indicator.
6. Adjust the fluid level.
7. Inspect for fluid leaks.