Rear

Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.





3. Remove the rear stabilizer shaft link (1) nut.





4. Disconnect the rear stabilizer shaft link from the strut.
5. Remove the stabilizer shaft link (1).

Installation Procedure





1. Install the stabilizer shaft link (1).
Tighten the stabilizer shaft link nut to 35 Nm (26 ft. lbs.).
2. Connect the stabilizer shaft link to the strut.
Tighten the stabilizer shaft link to strut nut to 35 Nm (26 ft. lbs.).
3. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
4. Lower the vehicle.