Rear

Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.





2. Remove the bolt from the stabilizer shaft insulator bracket (3).
3. Remove the stabilizer shaft insulator bracket.
4. Remove the stabilizer shaft insulator (2) from the stabilizer shaft.

Installation Procedure





1. Install the stabilizer shaft insulator (2) to the stabilizer shaft.
2. Install the stabilizer shaft insulator bracket (3).

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the stabilizer shaft bracket nut.
Tighten the nut to 48 Nm (35 ft. lbs.).
4. Lower the vehicle.