Turn Signal & Multifunction Switch - Disassemble

Disassembly Procedure
1. Remove the upper and lower shrouds. Refer to Trim Covers, Shift Lever Seal - Disassemble - Off Vehicle.





2. Pop the wire harness assembly (1) out of the wire harness strap (2).
3. Remove the small wire harness straps from the wire harness assembly (1).
4. Disconnect the connectors of the turn signal and multifunction switch assembly.





5. Remove 2 pan head tapping screws from the turn signal and multifunction switch assembly.
Remove the turn signal and multifunction switch assembly.