Turn Signal & Multifunction Switch - Assemble

Assembly Procedure

Important: The electrical contact of the turn signal and multifunction switch assembly must rest on the contact of the turn signal cancel cam assembly.

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the turn signal and multifunction switch assembly and secure by using 2 pan head tapping screws.
Tighten the screws to 7 Nm (62 inch lbs.).





2. Reconnect the connectors of the turn signal and multifunction switch assembly.
3. Install the new wire harness straps onto the wire harness assembly (1).
4. Install the wire harness assembly (1) into the wire harness strap (2).
5. Install the upper and lower shrouds. Refer to Trim Covers, Shift Lever Seal - Assemble - Off Vehicle.