Tilt Spring - Assemble

Assembly Procedure





1. Install the spring guide to the tilt spring. Lubricate with synthetic grease.

Caution: The tilt spring and the spring guide are under pressure and could become a projectile. During the disassembly and assembly procedures, secure the It spring. Exercise caution when removing or installing the tilt spring and the spring guide, as bodily injury may result.





2. Install the tilt spring (1).
2.1. Install the tilt spring (1) to the post on the steering column support assembly (2).
2.2. Secure the tilt spring (1).
3. Install the upper and lower shrouds. Refer to Trim Covers, Shift Lever Seal - Assemble - Off Vehicle.