Pulley Removal and Installation

Removal Procedure

Tools Required
- J 25033-C Power Steering Pump Pulley Installer
- J 25034-C Power Steering Pump Pulley Remover

1. Remove the power steering pump assembly from the vehicle. Refer to Power Steering Pump Replacement.





2. Using the J 25034-C Remove the power steering pump pulley from the power steering pump.

Installation Procedure

Important:
- Never use a hammer to install the power steering pulley.
- Do not use an arbor press to install the power steering pulley.
- The face of the pulley hub must be flush with the end of the pump driveshaft.





1. Using the J 25033-C Install the power steering pump pulley to the power steering pump.
2. Install the power steering pump assembly to the vehicle. Refer to Power Steering Pump Replacement.