Shoulder Belt Guide Adjuster Replacement-Front (Impala)

REMOVAL PROCEDURE
1. Remove the center pillar upper trim panel.
2. Remove the shoulder belt guide adjuster bracket bolts.






3. Remove the shoulder belt guide belt adjuster bracket from the center pillar.

INSTALLATION PROCEDURE

IMPORTANT: Verify that the release lever is at the top of the adjuster bracket in the full up position.




1. Position the shoulder belt guide adjuster bracket to the center pillar.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the bracket bolts to the shoulder belt guide adjuster.

Tighten
Tighten the bracket bolts to 42 N.m (31 lb ft).

3. Install the trim panel for the upper center pillar.