Bracket Replacement - Knee Bolster (Passenger)

REMOVAL PROCEDURE
1. Remove the instrument panel (IP) trim pad.
2. Reposition the RH IP accessory wiring junction block.
3. Disconnect the wiring harness retainers from the knee bolster bracket.
4. Remove the IP passenger knee bolster bracket bolts.
5. Remove the IP passenger knee bolster bracket.

INSTALLATION PROCEDURE
1. Align the instrument panel (IP) passenger knee bolster bracket to the IP.

IMPORTANT: Mandatory torque sequence indicated.

2. Install the IP passenger knee bolster bracket bolts at the instrument carrier in the sequence shown.

Tighten
Tighten the IP passenger knee bolster bracket bolts to 10 N.m (89 lb in).

3. Connect the wiring harness retainers to the IP passenger knee bolster bracket.
4. Install the RH IP accessory wiring junction block.
5. Install the instrument panel (IP) trim pad.