Spotlamp Travel Adjustment (SEO)

1. Loosen the spotlamp bracket clamp bolt.
2. Grasp the spotlamp.
Slowly rotate the spotlamp inboard until the shaft contacts the parkstop position.
3. Rotate the spotlamp slowly outboard to 5 degrees past the vertical position in order for the backstop to be in motion and the outer tube shaft to rotate.
4. Tighten the bracket clamp bolt sufficiently, in order to prevent the outer shaft tube from rotating while the spotlamp is moving between the stop positions.
5. Rotate the spotlamp head inboard to the parkstop position in order to prevent the spotlamp from coming in contact with the body components.
6. Position the parkstop of the shaft in order to rotate the spotlamp on its axis, clearing the nearest body components by 13-0.5 mm (0.50-0.02 in).
7. Tighten the bracket clamp screw when the parkstop has been set, in order to prevent rotation of the spotlamp shaft.

Tighten
Tighten the spotlight bracket clamp bolt to 6 N.m (53 lb in).




8. Adjust the spotlamp head clamping bolt, in order to easily rotate the spotlamp (1200) in any adjustable position between the parkstop and the backstop positions.
The total motion of the spotlamp is approximately 90 degrees.

Tighten
Tighten the spotlight head clamping bolt to 2.5 N.m (22 lb in).