Spotlamp Bulb Replacement (SEO)

REMOVAL PROCEDURE




1. Remove the spotlamp wiring harness push-in retainer from the windshield garnish molding, using a small flat bladed tool.
2. Disconnect the electrical connector.

IMPORTANT: Hold the spotlamp seal beam in position.




3. Remove the screws from the spotlamp bezel.




4. Remove the spotlamp bezel from the spotlamp.




5. Remove the sealbeam from the spotlamp.




6. Loosen the screws to the electrical connectors on the back of the spotlamp sealbeam.




7. Remove the electrical connectors from the back of the spotlamp sealbeam.
8. Remove the sealbeam from the spotlamp.

INSTALLATION PROCEDURE




1. Connect the electrical connectors to the back of the sealbeam.




2. Tighten the screws to the electrical connectors.

Tighten
Tighten the screws to the electrical connectors to 2 N.m (18 lb in).

IMPORTANT: The sealbeam must be clocked in the UP position, refer to the emblem on the face of the sealbeam.




3. Install the sealbeam to the spotlamp.




4. Hold the spotlamp seal beam in position.
5. Install the spotlamp bezel to the spotlamp.




6. Install the screws from the spotlamp bezel.

Tighten
Tighten the screws to the spotlamp bezel to 2 N.m (18 lb in).




7. Install the spotlamp wiring harness push-in retainer from the windshield garnish molding, using a small flat bladed tool.
8. Connect the electrical connector.
9. Inspect the spotlamp for proper operation.