Glove Box Lamp: Service and Repair

REMOVAL PROCEDURE
1. Open the instrument panel compartment door.
2. Remove the instrument panel compartment lamp switch using a small flat-bladed tool, to depress the retaining tabs.
3. Remove the compartment lamp switch from the instrument panel.
4. Disconnect the electrical connector from the instrument panel compartment lamp switch.
5. Remove the instrument panel compartment lamp switch.
6. Remove the bulb from the instrument panel lamp switch.

INSTALLATION PROCEDURE
1. Install the bulb to the instrument panel compartment lamp switch.
2. Connect the electrical connector to the instrument panel compartment lamp switch.
3. Install the instrument panel compartment lamp switch into the opening in the instrument panel compartment, pressing in until fully seated.
4. Close the instrument panel compartment door.