Air Distributor Duct Replacement (IP/RH/Defrost)

REMOVAL PROCEDURE




1. Remove the cross vehicle beam.
2. Remove the RH/Defrost IP air duct retaining bolts and screw.
3. Remove the RH/Defrost IP air duct from the cross vehicle beam.

INSTALLATION PROCEDURE




1. Install the RH/Defrost air duct to the cross vehicle beam.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the air duct center screw.

Tighten
Tighten the air duct center screw to 1.8 N.m (16 lb in).

3. Install the air duct bolts.

Tighten
Tighten the air duct bolts to 10 N.m (89 lb in).

4. Install the cross vehicle beam.