Air Distributor Duct Replacement (IP/RH)

REMOVAL PROCEDURE




1. Remove the instrument panel (IP) trim pad.
2. Remove the IP RH air duct retaining bolts.
3. Remove the IP RH air duct from the cross vehicle beam.

INSTALLATION PROCEDURE




1. Install the IP RH air duct to the cross vehicle beam.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the air duct bolts.

Tighten
Tighten the air duct bolts to 10 N.m (89 lb in).

3. Install the IP trim pad.