Air Distributor Duct Replacement (IP/LH/Center)

REMOVAL PROCEDURE




1. Remove the instrument panel (IP) trim pad.
2. Remove the LH/Center IP air duct retaining bolts.
3. Remove the LH/Center IP air duct from the cross vehicle beam.

INSTALLATION PROCEDURE




1. Install the LH/Center air duct to the cross vehicle beam.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the air duct bolts.

Tighten
Tighten the air duct bolts to 10 N.m (89 lb in).

3. Install the instrument panel.